CE CT Z6 Running Tool
The CE CT Z6 Running Tool is used to run the DB Series Lock Mandrels and attached subsurface control devises into the compatible Profile Nipple.
The Lock Mandrel is made up to the CE CT Z6 Running Tool at the surface and the run in the hole. During tripping in hole circulation through the Z6 Running Tool Choke is kept low to keep the tool string pressure below the Z6 Running Tool activation pressure. When the Lock Mandrel reaches the Profile Nipple No-Go Shoulder, increasing the tool string pressure will activate the Z6 Running Tool and it fully sets the Lock Mandrel. An overpull force confirms the Lock Mandrel has been set correctly. Upwards overpull or light jarring actions release the Z6 Running Tool from the Lock Mandrel.
FEATURES AND BENEFITS
– Set DB Series Lock Mandrels Hydraulically on CT
– An Overpull action confirms the Lock Mandrel has been set correctly
– A tattle-tale Garter Spring on the CT Z6 Running Tool provides a positive indication that the Lock Mandrel was fully set
– Dressed for H2S service